The knuckle was extracted from the left/driver side of the vehicle. The wheel bearing is manufactured by Koyo.
The ball joint is a Moog K9802. Ball joint's rubber boot was separated before installation, to prevent it from being torn. This required bending and discarding the boot retaining ring. Bearing and joint were installed using'constant torque', i. Pressed in, as opposed to'instant torque', i.
Hammer hits or impact wrench. I make no guarantee the steering knuckle will be within spec, more specifically the camber.
As seen in the image, a previous scavenger, had extracted the engine and transmission from the car. Splash guard/plate, is secured using screws that utilize a 3mm allen key hex head as opposed to a standards philips head on the OEM M5 screws.The old screws had to be drilled out due to being seized. The item "Acura Integra 94-01 Steering Knuckle with New Wheel Bearing and Ball Joint, Left" is in sale since Monday, October 5, 2020. This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts\Suspension & Steering\Control Arms & Parts". The seller is "tsambrosis" and is located in Rosedale, Maryland. This item can be shipped to United States, Canada.